Seat Rail Templates and Kits

 

 

Templates make the job of transferring the original Cessna rivet hole pattern from the old seat rail to the new seat rail easy!


 

  • Inexpensive
  • Achieve a precise fit every time

 

One template per seat rail is required

 

SRTEM1 = 1.5" x 38.0" x 0.025"

SRTEM2 = 2.25" x 30.0" x 0.025"

SRTEM3 = 1.5" x 58.63" x 0.025"

SRTEM4 = 1.5" x 71.5" 0.025"

 

To learn more go to Templates.

 

 

Spotface Kit for Cessna Seat Rails

The Spotface Kit tool contains a tool used with an electric drill to make a flat spot for screws.

This tool is specifically modified to provide rail cap clearance for use on seat rails.

Cutter comes with 1/8", 5/32" and 3/16" pilots.

 

Components also sold separately:

 

For ordering information go to Spotface Kit.

 

 

 

Rivet and Screw Kits

McFarlane offers either rivets or screws as convenient kits containing AN and MS hardware. Since it is difficult to install many of the rivets required to attach the seat rail, it is permissible to substitute screws with ultimate tensile strength exceeding 50 ksi with lock nuts provided the holes are ream fit and spotfaced. Each kit contains enough rivets or screws to install four seat rails. Installation hardware items are also available separately.

 

  1. When replacing a seat rail, note the number and location of all fastener holes on the seat rail being removed.
  2. Match these holes against the holes in the replacement seat rail. If the replacement seat rail does not have all of the same holes at the same locations, they must be drilled.
  3. Since it is difficult to install many of the rivets required to attach the seat rail, it is permissible to substitute screws with ultimate tensile strength exceeding 50 ksi.

 

Go to Rivet Kits or Screw Kits to learn more.

 

 

 

To view similar products for your aircraft go to Seat Rails and Seat Rail Components.

Custom Seat Rails also available.

 

Share this article: