McFarlane Aviation Products FAA-PMA Replacement Aircraft Parts



Learn more about AeroLEDs.


AeroLEDs offer high efficiency, direct replacement LED lighting for hundreds of aircraft. AeroLEDs are light weight, shock and vibration resistant, and have low drag. LED lighting easily lasts over 50,000 hours of continuous operation with no reduction by on/off cycles, with up to 80% reduced power consumption. The built-in Pulse Mode and synchronization blink the light on and off at a 1Hz rate when power is applied to the Pulse Mode power wire. Higher color temperature provides superior visibility and clarity.   





Landing and Taxi Lights
Nav/Position/Strobe Lights


TSO direct replacements with Form 337 for the obsolete Aeroflash system


Aeroflash Beacon
AeroLEDs Beacon

Know the difference...


Original light
AeroLEDs Light
Reduced drag!

Increased Safety

AeroLEDs lights allow you to comply with the latest FAA recommendations (Operation Lights On) regarding extended use of taxi, landing and anti-collision lights without fear of reduced light performance or life. They all feature optimized light color (6500k sunlight equivalent) for proven superior air-to-air recognition. The landing lights also feature a pulsed recognition light mode. 


Reduced Power Consumption

High efficiency LED lights use less than 1/3 the power of halogen bulbs. They significantly reduce the load on the electrical system and they will not dim due to low voltage typical of low RPM final approaches when you need them most!


Longer Life - Zero Maintenance

All AeroLEDs products are designed to be a "lifetime buy." They last over 50,000 hours when properly installed and do not degrade with on/off cycles. They are extremely rugged and hardened against all kinds of electrical damage, shock and vibration. 


Pulse Recognition Mode

AeroLEDs lights with pulse mode (or wig-wag mode) greatly improve safety by alternately blinking the left then right light once per second. This dramatically increases your aircraft visibility to prevent both air and ground collisions. At least one 36HX or 46HX series light must be installed to enable pulse mode.



Up to 7 times brighter than other LED landing lights!

PAR36 Landing Light Comparison  
Measured Brightness at 50 ft
Manufacturer Intensity Lumens
AeroLEDs 100.7  11,000 
GE4509  67 1500 
Whelan Parmetheus Plus  65  1700 
Rigid Industries  50.4  3400 
Alphabeam  39.7  5600