Cessna and Piper Seat Rollers

Now also approved for 300-400 series aircraft! McFarlane seat parts were developed to assist in complying with the parts replacement requirements of FAA Airworthiness Directive 87-20-03. This AD requires the periodic inspection and replacement of seat components of the entire Cessna light aircraft fleet. Our parts are direct replacements for the wear related seat components. All parts are available individually or as convenient kits.

SEAT-KT-1 Roller diameter approximately 1 3/8”

This kit is used with the “infinitely adjustable” or “articulating” seats installed in the Cessna single engine aircraft from 1963 through 1986. Two adjustment crank handles identify this seat. The backrest angle is adjusted with a crank. It is also used with some 336-337 series aircraft. The SEAT-KT-1 contains the same components as four of the Cessna 1714000K200 kits. 

Notes:

• All seats in the 177 Cardinal will use the large seat roller and require this kit.
• These parts are not used on models 150-152. 

SEAT-KT-2 Roller diameter approximately 5/8”

This kit is used with the “Standard” or “Vertically adjustable” seat installed in Cessna single engine aircraft from 1963 through 1986. This seat is identified by one or no adjustment crank handles. The seat back angle is adjusted with a lever on the side of the seat back. It is also used with some 336- 337 series aircraft. The SEAT-KT-2 contains the same components as four of the Cessna 1414100-212 kits. 

Note: These parts are not used on models 150-152.

SEAT-KT-3 Roller diameter approximately 7/8” with no wear washers

This kit is used with all seats in the Cessna 150-152 series aircraft and all Cessna single engine aircraft built before 1963. A welded steel tubing seat frame easily identifies these seats. It is also used with some Cessna twin engine aircraft.