LIGHT, Landing/Taxi, SunSpot, Par 36,

Sunspot FAA-PMA/STC Landing and Taxi Lights

Drop-in replacement for PAR36, 46, 27 and 64
Almost twice the light for 1/3 the power!

• Huge power savings
• Light weight
• Less heat
• Whiter light - more like daylight
• Improved safety with pulse recognition mode
• Long life - over 50,000 hours!
• FAA certified

Available as a drop-in replacement for PAR36, PAR46, PAR27, and PAR64 configurations with several options that are FAA/PMA/STC certified. The AeroLEDs Sunspot Series LED Landing and Taxi Lights consume less power, output more lumens (total light output) and are not affected by vibration compared to incandescent bulbs. These attributes make the SunSpot ideal for use in Experimental, Certified, Commercial, ARFF, and Military aircraft. The HX version includes an integrated Pulse or WigWag feature that helps greatly increase recognition in broad daylight as well as night operation to help avoid midair collisions. Additionally, while in the recognition mode, SunSpot’s draw half the current. The SunSpot series lights are designed to be mounted in the wingtips, leading edge, cowling, or on the landing gear.

Pulse Recognition Mode.

AeroLED lights with pulse mode (or wig-wag mode) greatly improve safety by alternately blinking the left then right light once per second. This dramatically increases your aircraft visibility to prevent both air and ground collisions. At least one 36HX or 46HX series light must be installed to enable pulse mode.

AeroLEDs offer high efficiency, direct replacement LED lighting for hundreds of aircraft

AeroLEDs are light weight, shock and vibration resistant, and have low drag. LED lighting easily lasts over 50,000 hours of continuous operation with no reduction by on/off cycles, with up to 80% reduced power consumption. The built-in Pulse Mode and synchronization blink the light on and off at a 1Hz rate when power is applied to the Pulse Mode power wire. Higher color temperature provides superior visibility and clarity.   

Increased Safety

AeroLEDs lights allow you to comply with the latest FAA recommendations (Operation Lights On) regarding extended use of taxi, landing and anti-collision lights without fear of reduced light performance or life. They all feature optimized light color (6500k sunlight equivalent) for proven superior air-to-air recognition. The landing lights also feature a pulsed recognition light mode. 

Reduced Power Consumption

High efficiency LED lights use less than 1/3 the power of halogen bulbs. They significantly reduce the load on the electrical system, and they will not dim due to low voltage typical of low RPM final approaches when you need them most!

Longer Life - Zero Maintenance

All AeroLEDs products are designed to be a "lifetime buy." They last over 50,000 hours when properly installed and do not degrade with on/off cycles. They are extremely rugged and hardened against all kinds of electrical damage, shock and vibration. 

Pulse Recognition Mode

AeroLEDs lights with pulse mode (or wig-wag mode) greatly improve safety by alternately blinking the left then right light once per second. This dramatically increases your aircraft visibility to prevent both air and ground collisions. At least one 36HX or 46HX series light must be installed to enable pulse mode.